Read All Instructions Prior to Installation

Check all parts for defects or burrs and fit before installing

Components:

• Chin Spoiler
• (14) Self-Tapping Screws

Tools Required:

• Phillips Screw Driver
• Masking Tape or Duct Tape

 Chin Spoiler Instructions

Chin Spoiler Install

1. Raise front of vehicle using ramp, hoist, etc.

2. Line up Chin Spoiler to be flush with the outside front lip of the wheel well on each side of vehicle using tape to temporarily hold in place.

3. Once the Chin Spoiler is taped into place check fit along front edge.  Note:  Chin Spoiler will be flush with the front fascia for about 4 to 5" until it goes behind the leading edge of the fascia.

4. If satisfied with the fit along the front edge, drill 1/4" hole use supplied fasteners to fasten the chin spoiler to the fascia.  Start at the outside edge by the wheel well and work you way towards the center.  Repeat for the other side

5. Remove Tape